My Photo

« Bricscad Troubleshooting Tip : How to enable VBA / ACIS Editing in your Bricscad? | Main | A CAD Tutorial : Visibility Control of Entities Contained in Block Inserts »

August 21, 2012


Feed You can follow this conversation by subscribing to the comment feed for this post.

Jason Bourhill


What about the recently introduced PUBLISH command? I think this provides more than Batchplot, and I'm sure will be improved further with V13.

Rakesh Rao

Thanks Jason for pointing that out. I have not tried the PUBLISH command but, yes, I now read on the forums as well that it is an alternative to using the old PLOT DVB file.

Warm regards....

Look forward to meeting you in Amsterdam.

Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)